-
Gas Tank Accesories
gories-miscellaneous-products-gas-tanks-accesories
-
Fuel Gauge and Sender
Fuel Gauge: for vehicles using aux. fuel tanks. Replaces orig. equipment wherever a 2 1/8" panel hole exists. Uses fuel sender M-5613. Sender (tank unit): adjust for 6" - 24" deep tanks; std. 5-hole SAE mounting flange, cork neoprene gasket and sealed mounting screws. Adjusts to right or left-hand float arm direction.
-
Aluminum Diesel Caps
Non-locking, vented cap meets venting requirements of BMCS 393.67 for vehicles built after October 1985
-
Brass Gas / Diesel Caps
Non-locking, vented caps for use only on vehicles with non-vented fuel systems built prior to October 1985
-
Non-Vented Diesel Caps
- Polished aluminum casting
- Meet DOT FHA BMCS # 393.67 requirements
-
Vented Diesel Caps
- Polished aluminum casting
- Meet DOT FHA BMCS # 393.67 requirements
-
Motor Driven Selector Valves Three And Six Port
Motor operation allows for substantially higher closing pressures than solenoid-activated valves. Valve remains in actuated position after power is disconnected, reducing the possibility of returning fuel to incorrect tank. Both valves come with a connector and switch. Installation sheet included.
Note: 5 amps draw max. at 12 volt, fits 3/8" I.D. hose for fuel supply and 5/16" hose for return lines. Mounting holes 2 5/16" threaded nuts on 1 3/16" centers. -
Oil Pressure Gauge and Sender
-
Ammeters
Ammeters
(2)Shows direction and amplitude of current flow. Recommended for low output alternators and low electrical loads. Electrical connection: Alternator/Regulator output goes to terminal marked “S.” Terminal marked “I” goes to battery.
-
Filler Neck Adapter Kits
-
12V Pilot Light
12V Red 1/2" diameter faceted lens. For panel mounting through 5/16" hole. Has a snap-out socket for conventional bulb replacement.
-
Ball Valve
Designed for fuel line shutoff in gasoline and diesel vehicles. May also be used for water and air service lines. Heavy-duty forged brass body provides extended service. Teflon® seats and seals provide positive sealing with easy opening and closing. 600 psi water, oil or fuel. 150 psi on/off saturated steam service. 29 in. Hg vacuum service.
-
Mounting Panels and Light Kit 2" Gauges and Meters
Black steel panel blanks.
-
Gas Tank Filler Hose (Softwall)
Used as a fill neck hose, this product can carry leaded, unleaded,oxygenated fuels with aromatics of up to 30%, gasohol and diesel fuel. This hose is suitable for use on passenger cars, light trucks, boats and auxiliary fuel tanks on RV's. This product is similar to SAE 30R7 specifications and its rugged construction helps prevent hose collapse. Temperature Resistance: -34°F to +257°F
